nmcli). Once you connect to a network, its password is
saved and the robot connects to that network automatically on subsequent boots. In a new environment such as a
competition venue, school or home, the robot’s network must be added once.
1. Connecting to the Board Without a Network
Since the robot is not yet connected to the new network, it cannot be reached over Wi-Fi. Connect to the board using one of the following methods.- USB Type-C (recommended)
- Serial console
- Monitor and keyboard
Connect T3 Gemstone O1 to your computer with a USB Type-C cable. When the board boots (about 1 minute), a USB network
interface appears on the computer and the board becomes reachable at The user name is the one you set when writing the image. On the first connection, answer
192.168.7.2.yes to the “host key”
question. If the board was re-imaged, you will get a “REMOTE HOST IDENTIFICATION HAS CHANGED” warning; in that case
remove the old entry.2. Adding a Network
Scan for and list nearby networks.successfully activated, the connection has been saved.
Enterprise network (WPA2-Enterprise / eduroam)
Enterprise network (WPA2-Enterprise / eduroam)
For networks that require a user name and password:
peap/mschapv2 is the most common setting; if the network administrator specifies a different method, use that
instead.Phone hotspot
Phone hotspot
A phone hotspot is added like any other network. If there is no network at the track, this is the easiest method.
The robot and the computer that will open the interface must be connected to the same hotspot.
3. Finding the Robot’s IP Address
The network assigns an address to the robot via DHCP, and the address is different on every network.wlan0 UP 10.0.10.91/23. The web interface is reached at http://<this-address>:8000. The
computer that will open the interface must be on the same network as the robot.
Some enterprise and guest networks prevent devices from seeing each other (client isolation). If the interface does
not open, try a phone hotspot.
4. Managing Saved Networks
Troubleshooting
Secrets were required, but not provided
Secrets were required, but not provided
The password is wrong, or the network is an enterprise network. For enterprise networks, use the enterprise network
command above.
No network with SSID ... found
No network with SSID ... found
The network may be broadcasting on the 5 GHz band and the board does not see it, or the board is out of range.
Check the
nmcli dev wifi list output.Connected, but the interface does not open
Connected, but the interface does not open
- Is the robot software running? If the service is installed, check with
systemctl status ugv. - Is the computer on the same network as the robot?
- Does the network isolate devices from each other (client isolation)?

